Changing Speeds - Grizzly G1095 Owner's Manual

Changing Speeds

To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
This power feeder can feed workpieces at 13, 26,
33, or 66 feet per minute.
Users can change feed rates by switching change
gears and by turning the motor switch to the low-
range or high-range operation.
To change power feeder feed rate:
1. Make sure speed dial points to "0" (OFF
position, see Figure 16).
Figure 16. Adjusting feed direction and speed.
-20-
2. DISCONNECT MACHINE FROM POWER!
3. Remove chain cover and two hex nuts
securing A & B change gears to shafts shown
in Figure 17.
Change Gear
Position A
Change Gear Position B
Figure 17. Change gear locations.
4.
Use list below to find gear combination
required for chosen feed rate.
13 Ft. Per Min.: A, 25 Tooth + B,
40 Tooth.
26 Ft. Per Min.: A, 40 Tooth + B, 25
Tooth.
33 Ft. Per Min.: A, 25 Tooth + B, 40
Tooth.
66 Ft. Per Min.: A, 40 Tooth + B, 25
Tooth.
Motor OFF.
5. Swap change gears so gear hubs face in
toward power feeder (shown in positions A &
B in Figure 17).
6.
Re-install hex nuts and chain cover.
7.
Connect power feeder to power, and move
feed direction and speed dial to low or high
range.
Model G1095/G1096 (Mfd. Since 8/15)