Base Mounting - Grizzly G1095 Owner's Manual

Base Mounting

Position the power feeder on the table top to
determine where to drill the base mounting holes
in order to maximize power feeder swing and
adjustment options.
Use the base-bolt pattern template to align the
mounting holes. Consider the available mounting
choices for your needs: Through-Bolt Mounting
and Direct Mounting (discussed on Page 17).
With either mounting choice, leave room to oper-
ate the handcranks and lock levers to position the
rubber wheels parallel with the table surface and
approximately ⁄ " lower than the thickness of the
1
8
workpiece.
Shaper
4th-Roller
Models
Feed
Figure 12. Typical power feed mounting on a shaper, jointer, and table saw.
-16-
Jointer
Fence
Cutter
Feed
Cutterhead
Also, aim the front of the power feeder slightly
towards the machine fence (see Figure 12)
with approximately 1° to 1.5° toe-in toward the
machine fence, so the rubber wheels lightly push
the workpiece against the fence during cutting
operations.
If cutting long or large stock that is difficult to feed
properly, use a featherboard before the power
feeder (on the infeed side) to maintain even pres-
sure and control of the workpiece against the
fence.
Table Saw
Fence
Blade
Optional
Featherboard
Model G1095/G1096 (Mfd. Since 8/15)
Fence
Feed