Grizzly G1095 Owner's Manual page 19

Through-Bolt Mounting
We recommend mounting the power feeder to
the machine table with through bolts, nuts, and
washers (see Figure 13). This option provides the
most rigidity and clamping strength to prevent the
feeder base from twisting out of alignment during
use. However, if under-table support webs inter-
fere with washer or nut locations, use the optional
clamping kit, or drill and thread holes directly into
the table as described in Direct Mounting.
Bolt
Feeder
Base
Machine Table
Table
Support
Webbing
Figure 13. Through-bolt mounting.
Model G1095/G1096 (Mfd. Since 8/15)
Flat Washer
Flat Washer
Lock Washer
Locking Hex Nut
Direct Mounting
Use the included mounting template to drill and
tap the table so the power feeder base can be
directly mounted to the table surface (see Figure
14). Use medium-grade liquid thread-locking com-
pound on all threads. If the table is less than
thick where the holes will be drilled and tapped,
or if support webbing interferes, the threads may
strip or loosen during power feeder use. Thread-
locking compound is not a permanent solution.
Revert to the Through-Bolt Mounting option.
Bolt
Feeder
Base
Machine Table
Apply a Medium
Table
Grade Thread
Support
Locking Compound
Webbing
to the Threads
Figure 14. Direct mounting.
3
Lock Washer
Flat Washer
-17-
⁄ "
8