Test Run - Grizzly G1095 Owner's Manual

Test Run

Keep hair, clothing, and
jewelry away from mov-
ing parts at all times.
Entanglement can result
in death, amputation, or
severe crushing injuries!
Once assembly is complete, test run the power
feeder to make sure it runs properly and is ready
for regular operation. The test run consists of veri-
fying that the motor powers up and runs correctly,
and that the rollers operate.
If you cannot easily locate the source of unusu-
al noise or vibration during the test run, stop
using the machine immediately, then review
Troubleshooting on Page 23.
If you still cannot remedy a problem, contact Tech
Support at (570) 546-9663 for assistance.
To test run power feeder:
1.
Understand all safety instructions at the
beginning of the manual, and verify that the
power feeder is adjusted and is set up prop-
erly.
2. Make sure that the power feeder gearbox oil
level is full. The oil level should be 1" below
the oil fill port. Refer to Lubrication on Page
21 for details.
Note: See Figure 19 on Page 21 for oil fill
port location.
3.
Ensure that all tools and objects used during
set up are cleared away from machine.
4. Adjust and lock the power feeder so the
wheels are held approximately 1" above the
table and nothing will interfere with wheel
rotation.
-18-
You MUST assemble all guards, fences, and
hold-downs before starting your machine or
power feeder. Failure to heed this warning
could result in amputation or death!
5. Connect the power feeder to the power sup-
ply, and use the feed direction and speed dial
(see Figure 15) to test operation in both feed
directions.
Figure 15. Feed direction and speed dial.
— Listen and watch for abnormal noises or
vibrations. The power feeder should run
smoothly.
— Correct for any unusual noises or vibra-
tions before operating the power feeder
any further. Always disconnect the power
feeder from power when investigating or
correcting potential problems.
6.
Turn the feed direction switch to "0" (OFF
position, see Figure 15).
Model G1095/G1096 (Mfd. Since 8/15)