Precor SPINNER CHRONO POWER Service Manual page 39

4. Cut the cable tie that is securing the battery to the cross member and remove the bat-
tery.
Installation procedure.
1. Place the battery on the cross member and secure with an 8" cable tie.
2. Carefully reconnect the battery cable Red wire to the Positive (+) battery terminal and
then the Black wire to the Negative (-) battery terminal. Reconnect the Negative ter-
minal cable last.
3. Slowly pedal the bike enough to power ON the console, access the console service test
menu BAT VOLT parameter (see
Continue pedaling and verify that the battery voltage is between 6.0 - 7.5 vdc, then stop
"Spinner® Chrono™ Console" on
5 Replacement Procedures
Battery Replacement
page 147).
32