Setting The Partial Expanded Recording - YOKOGAWA MuR10000 Manual

6.5

Setting the Partial Expanded Recording

Procedure
Explanation
6-6
This section explains the details of expanding a section of the recording range.
If you change the input range, set the partial expanded recording again.
1.
Hold down the
MENU
2.
Press the key or SHIFT +
3.
Press the key or SHIFT +
key.
4.
Set each item and press the
key or SHIFT +
Use the
For the procedure on how to enter values or characters, see section 4.2.
If you press the ESC key in the middle of the operation, the settings entered up to
then are cancelled, and the display returns to a higher level menu.
5. When the Setting complete screen appears, do either of the following:
Press the key to set other channels.
If you are done, press the ESC key.
6.
Hold down the
MENU
Set=Aux
Aux=Partial
CH=01-01
First channel Last channel
Partial=Off
Expand=50
Boundary=
01-01 Channel
ESC/? Setting complete
Expand
Set a value between 1 and 99%. One percent corresponds to 1 mm, because the record
width is 100 mm.
Example: To record 0 to 8 V in the 0 to 50% position and 8 to 10 V in the 50% to 100%
position with a span of 0 to 10 V, set the boundary position to 50% and the
boundary value to 8.00 V.
<Related Topics> Enabling the partial expanded recording function: Section 7.13
key for 3 seconds to enter Setting mode.
key to select Aux and then press the
key to select Partial and then press the
key.
key to select values.
key for 3 seconds to return to Operation mode.
Set the channel range.
Select On to use the partial expanded
recording function.
Set the boundary position as a
percentage where the recording span
is assumed to be 100%.
Set the boundary value within the
0.000
recording span.
The new setting takes effect.
key.
IM 04P01B01-01E