Recommended Replacement Periods For Worn Parts - YOKOGAWA MuR10000 Manual

11.7 Recommended Replacement Periods for Worn
Parts
Pen Model
Z-fold chart paper 33 days
Felt pen
Plotter pen
Display
Chart paper feed
motor
Plotter carriage
Plotter motor
Lever bearing
Pen servo
Internal light LED
Dot Model
Z-fold chart paper 33 days
Ribbon cassette
Display
Chart paper feed
motor
Lever
Pulley
Carriage motor
Carriage
Ribbon shift motor 5 years
Ribbon shift gear
Ribbon feed motor 5 years
Ribbon feed gear
Internal light LED
11-10
To preserve the reliability of the recorder and to use the recorder in good condition for
an extended time, it is recommended that periodic replacements be made on parts. The
replacement parts may change to accommodate preventive maintenance over extended
time. Be sure to check with your nearest YOKOGAWA dealer.
The table below shows the recommended replacement period for expendable parts.
The replacement period shown here applies when the recorder is used under standard
operating conditions. For the actual replacement period, consider the actual conditions of
use.
Replacement of parts other than the chart paper, pen, ribbon cassette, and internal light
LED will be carried out by a YOKOGAWA engineer or an engineer certified by YOKOGAWA.
Contact your nearest YOKOGAWA dealer when such replacement is necessary.
Note
The replacement period of the display and the internal light LED is the half life of the brightness.
The deterioration of brightness varies depending on the condition of use, and its determination
is subjective. Consider these facts for determining the actual replacement period.
Replacement
Item
Period
2 km
60,000
characters**
5 years*
5 years
5 years
5 years
5 years
5 years
2 years*
* The half life of the brightness at the factory default brightness setting.
** Smearing may occur around the ridge-folding part of the chart paper.
Replacement
Item
Period
3 months
5 years*
5 years
3 years
3 years
5 years
5 years
5 years
5 years
2 years*
* The half life of the brightness at the factory default brightness setting.
Part Name Part No.
CHART B9565AW When used at 20 mm/h
B9902AM
B9902AN
PEN ASSY
B9902AP
B9902AQ
PEN ASSY B9902AR When printing continuously
DISPLAY ASSY B8800CA
MOTOR ASSY B9962EJ
CARRIAGE ASSY B8800DJ
MOTOR ASSY B8800DT
BEARING B9900RP For the plotter
SERVO ASSY B8800GG
LED ASSY B8800CR
Part Name Part No.
CHART B9565AW When used at 20 mm/h
RIBBON CASSETTE B9901AX
DISPLAY ASSY B8800CA
MOTOR ASSY B9962EJ
LEVER ASSY B9901EK
PULLY B9963CJ
MOTOR ASSY B9963CF
CARRIAGE ASSY B9963CL
MOTOR ASSY B9962EJ
B8801BX
GEAR
B8801BW
MOTOR ASSY B9962EJ
B9901HL
GEAR B9901HM
B9901HN
LED ASSY B8800CR
Note
Red
At a pen speed
Green
Blue
of 10 cm/s
Violet
For the X-axis
Shared by all pens (excludes
the pen arm ASSY)
Note
For the carriage
For the carriage
IM 04P01B01-01E
Quantity
Used
1
1 each
1
1
1
1
1
1
1 to 4
1
Quantity
Used
1
1
1
1
1
2
1
1
1
1 each
1
1 each
1