Before Installing Your Ventilation Hood; Preparing For Installation - Fisher & Paykel HC24PHTX1 Installation Instructions Manual

Recirculating
To enable the product to operate with the air recirculating, please purchase a recirculation diverter and carbon filters
(refer to the 'Parts and accessories' section). This recirculation diverter is required to channel the air out the side vents
at the top of the chimney and the carbon filters are required to remove odors.
A ducting hole is not required in the wall or ceiling if the ventilation hood is installed to
operate with exhaust air recirculating.
•
•
Wear gloves to protect against sharp edges.
The manufacturer is not liable for any damage caused by not following these instructions.
Installation

1. Preparing for installation:

Before installing your ventilation hood:

• Please read the instructions carefully.
• Unpack the ventilation hood.
• Ensure the voltage (V) and the frequency (Hz) indicated on the serial plate match the voltage and
frequency of the installation site.
• Check that the area behind the installation surface to be drilled is clear of any electrical cables or pipes
etc
• The ventilation hood surfaces can be damaged during installation if grazed or knocked by tools. Please
take care to protect the surfaces during installation.
• Protect the cooktop surface with cardboard, or the like, to prevent damage occurring whilst the ventilation
hood is being installed above.
https://producthelp.fisherpaykel.com/us/Cook/Ventilation/Pyramid/HC36PHTX1/User_Guide_HC36PHTX1/03_installation_instructions
This product is heavy and requires two persons for installation.
Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable codes and standards.
Updated: Sun, 04 Nov 2018 05:00:28 GMT
Powered by
7