Table of Contents
Advertisement
Accessories Installation
Installation of Wired Remote Controller
1. Please fix tightly using provided screw after
placing remote controller setup board on the
place where you like to setup.
- Please set it up not to bend because poor
setup could take place if setup board bends.
Please set up remote controller board fit to the
reclamation box if there is a reclamation box.
2. Can set up Wired remote controller cable
into three directions.
- Setup direction: the surface of wall reclama-
tion, upper, right
- If setting up remote controller cable into upper
and right side, please set up after removing
remote controller cable guide groove.
h Remove guide groove with long nose.
① Reclamation to the surface of the wall
② Upper part guide groove
③ Right part guide groove
3. Please fix remote controller upper part into
the setup board attached to the surface of
the wall, as the picture below, and then, con-
nect with setup board by pressing lower
part.
- Please connect not to make a gap at the
remote controller and setup board's upper and
lower, right and left part.
When separating remote controller from
setup board, as the picture below, after
inserting into the lower separating hole
using screw driver and then, spinning clock-
wise, remote controller is separated.
- There are two separating holes. Please individ-
ually separate one at a time.
- Please be careful not to damage the inside
components when separating.
28 Hydro Kit
2
3
1
<Wire guide grooves>
<Connecting order>
Wall
Side
<Separating order>
Wall
Side
2
3
Wall
Side
Wall
Side
Hide quick links:
Advertisement
Table of Contents
