Wired Remote Controller Installation - LG L8UC100BFA2 Installation Manual

Installation of Indoor, Outdoor Unit

Wired remote controller installation

• Since the room temperature sensor is in the remote controller, the remote controller box should be installed
in a place away from direct sunlight, high humidity and direct supply of cold air to maintain proper space
temperature.
Install the remote controller about 1.5m above the floor in an area with good air circulation at an average
temperature.
Do not install the remote controller where it can be affected by:
- Drafts, or dead spots behind doors and in corners.
- Hot or cold air from ducts.
- Radiant heat from sun or appliances.
- Concealed pipes and chimneys.
- Uncontrolled areas such as an outside wall behind the remote controller.
- This remote controller is equipped with a seven segment LED. display. For proper display of the remote
controller LED's, the remote controller should be installed properly as shown in Fig.1.
(The standard height is 1.2~1.5 m from floor level.)
WIRING CONNECTION
• Remove the control box cover for electrical
connection between the indoor and outdoor
unit.
(Remove screws ➀.)
• Use the cord clamper to fix the cord.
20 Multi Type Air Conditioner
AUTO SWING OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
Time ZONE 1 2 3 4
Timer Operation unit Program set
On Off
Set no. Time 01 03 05 07 09 11 13 15 17 19 21 23
no
TIO N
NC
B FU hea t
SU r Pre ify
EE D ate t Hu mid r
SP O He fros Ou t doo
FA N AUT De er 4
HI JET Filt 2 3
MP 1
m Tem T TE p MED
SE LO 23
IO N Roo ZO NE 21
AT
OP ER 19
m e 17
ING Ti set 15
SW m 13
AU TO gra Pro 11
09
uni t 07
era tion 05
Op 03
er
Ti m Of f e 01
On Tim
Set no.
no
Fig.1 Typical locations for remote controller
yes
AUTO SWING OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
Time ZONE 1 2 3 4
Timer Operation unit Program set
On Off
Set no. Time 01 03 05 07 09 11 13 15 17 19 21 23
no
5feet
(1.5meters)
Control terminal board
Control box
1
Control box cover
(On which the Electric
Wiring Connection is put)
A A view
Remote
control cord
1
Cord clamper
Connection
cord between
the indoor unit
and the
outdoor unit