Operation - Grindmaster CS1-110 Operator's Manual

Programming (continued)
1. Turn on the programming switch. (see Figure I)
2. The LED of buttons 1 - 4 on the control panel will
be lit, and the fifth LED will flicker. This indicates
programming mode for setting up the amount of
continuous output. (See Figure J)
3. Place measuring cup under the brewing group.
Hold down the first button until reaching the
required amount of water. Do not otherwise touch
the panel. Meanwhile the first button's light will be
off, the other three buttons still lit, and the fifth
button flickers (see Figure K). It means the first
button is programmed. Continue programming
other buttons. Turn programming switch to OFF
when completed. Each time the programming
switch is turned ON, it will reset the buttons.
CS Espresso Machine

Operation

NOTICE:
be kept untangled and free of obstructions. Don't block
air intake or outlet vents on the machine. Never cover
or otherwise prevent the free flow of air across the cup
warmer.
NOTICE:
or any other substance containing chlorine. These
products promote corrosion and will pit the stainless
steel. USE OF THESE PRODUCTS WILL VOID THE
WARRANTY.
1. Place an appropriate quantity of ground coffee in
the Porta Filter and tamp the ground coffee firmly.
Clean all residual coffee from the rim and sides of
the filter. This is to ensure a good seal and full
pressure when brewing coffee, and prolong the
CAUTION: BURN HAZARD
Steam wand, hot water wand, and brewing unit are
Figure I
very hot. Use caution when operating unit to prevent
burns.
lifetime of the gasket. Attach the Porta Filter to the
machine by rotating until it locks in place.
2. Place cup(s) or glass(es) under spout(s).
3. Either press desired portion button or press and
hold the continuous flow button until desired
portion is dispensed. To stop flow at any time, press
and release continuous flow button. (See Figure L)
Figure J
4. Move cup(s) or glass(es) to side and remove Porta
Filter. Dump grinds. Carefully hold Porta Filter near
group head and rinse using the continuous flow
button water. Use extreme caution to avoid burns.
Then, fit empty Porta Filter to the brewing group
to store and keep warm.
Steam Wand:
This can be used by turning the knob counterclockwise,
which allows for a varied amount of steam or by pulling
out the handle which will dispense the maximum
amount of steam.
Figure K
Grindmaster ®®
To avoid overheating, electric wires should
Do not use cleansers, bleach liquids, powders
Figure L
7