[Setup - Options] - NEC LT25 User Manual

[Setup - Options]

Setting Off Timer [Off Timer]
You can use the Off Timer feature to turn off the projector automatically at a preset time.
Eight preset times can be selected:Off, 0:30, 1:00, 2:00, 4:00, 8:00, 12:00 and 16:00.
Enabling or Disabling Auto Focus [Auto Focus]
This option turns on or off the Auto Focus feature. (
NOTE:
When the "Auto Focus" is on, the Auto Focus function works instantly under the following conditions:
• When you turn on the power.
• When you change the zoom.
• When you reposition the projector.
Enabling Auto Start [Auto Start]
Turns the projector on automatically when the power cable is inserted into an active power outlet. This eliminates the
need to always use the POWER button on the remote control or projector cabinet.
Last ....................... When the projector is turned off with the POWER button (placed into stand-by mode) and then the power
cable is disconnected, Auto Start will not be activated after power (AC) is applied.
When the projector is turned off with the "Direct Power Off" function or after power (AC) is removed (no
stand-by mode), Auto Start will be activated after power (AC) is applied.
The "Direct Power Off" function means you can turn off the power (AC) to the projector using a power strip
equipped with a switch and a breaker.
Enabling Power Management [Power Management]
When this option is selected you can enable the projector to automatically turn off (at the selected time: 5min., 10min.,
20min., 30min.) if there is no signal received by any input.
Enabling Fan Speed Mode [Fan Mode]
This option allows you to select two modes for fan speed: Auto mode and High speed mode.
Auto ...................... The built-in fans automatically run at a variable speed according to the internal temperature.
High ...................... The built-in fans run at a fixed high speed.
When you wish to cool down the temperature inside the projector quickly, select [High].
NOTE: It is recommended that you select High speed mode if you continue to use the projector for consecutive days.
Selecting Signal Format [Signal Select]
[Computer]
Normally select [RGB/Component] and the projector automatically detects a component signal. Select [Scart] for the
European Scart signal.
[Video & S-Video System Select]
This feature enables you to select video standards automatically or manually.
Normally select [Auto] and the projector will automatically detect the video standard.
In the case where the projector has difficulty detecting the video standard, select the appropriate video standard from
the menu. This must be done for Video and S-Video respectively.
page 22)
43
5. Using On-Screen Menu