Connecting The Supplied Power Cable - NEC LT25 User Manual

Connecting the Supplied Power Cable

Connect the supplied power cable to the projector.
First connect the supplied power cable's three-pin plug to the AC IN of the projector, and then connect the other plug
of the supplied power cable in the wall outlet.
The projector will go into its
standby mode and the
power indicator will glow
orange.
CAUTION:
Do not try to touch the ventilation outlet on the right front (when seen from the front) as it can become heated while
the projector is turned on and immediately after the projector is turned off.
CAUTION:
Do not unplug the power cable from the wall outlet or projector when the project is powered on. Doing so can cause
damage to the AC IN connector of the projector and (or) the prong plug of the power cable.
TIP: To turn off the AC power supply when the projector is powered on, use a power strip equipped with a switch and a breaker.
TIP: The projector can be unplugged during its cool down period after it is turned off.
LAMP
STATUS
POWER
ON/STA
C O
M P
U T
E R
IN
V ID
E O
IN
S -V
ID E
O IN
A U
D IO
IN
P C
C O
N T
R O
L
16
2. Installation and Connections
Make sure that the prongs are fully inserted into
both the power plug and the wall outlet.
To wall outlet