Setting Up Your Remote Control To Operate Your Cable Box - Samsung TXL 2791F Owner's Instructions Manual

S
P E C I A L

Setting Up Your Remote Control to Operate Your Cable Box

1
Turn off your cable box.
2
On your Samsung remote control, press the SET button.
3
Press the CABLE button on the top right of your remote
control.
4
Enter both digits of the cable box code listed below for your
brand of cable box.
5
Press the POWER button. Your cable box should turn on. If your
cable box turns on, your remote control is now "set up" correct-
ly.
6
Once your remote control is set up, press the CABLE button
any time you want to use the remote to operate your cable
box.
Cable Box
Codes
F
E AT U R E S
The remote control has three
"modes": "TV," "VCR," and
"CABLE".
Press the "CABLE" button to switch
the remote control to the "Cable"
mode.
Make sure you enter both digits
of the code, even if the first digit is a
"0." (If more than one code listed,
try the first one.)
If your cable box does not turn
on, repeat steps 2, 3, and 4, but try
one of the other codes listed for your
particular brand of cable box. (If no
other codes are listed, try each cable
box code, 00 through 35.)
When your remote control is
in the "CABLE" mode, the volume
buttons still control your TV' s vol-
ume. Also, the VCR control buttons
(PLAY, PAUSE, etc.) will still operate
your VCR.
C F : S
HAPTER OUR PECIAL
4.3
F
EATURES