Additional Information - D-Link DWM-311 Quick Installation Manual

4g lte m2m modem

Hide thumbs Also See for DWM-311:

User manual (49 pages)

User manual (32 pages)

Quick installation manual (8 pages)

Table of Contents

Enlarged version

1. Verify your PoE splitter is set to output 5 volts.

Warning: Higher voltages may damage the

DWM-311.

2. Attach the PoE splitter's DC-OUT to the DWM-311's

mini-USB power input. The power input is

labelled with the symbol.

3. Attach the PoE splitter's LAN OUT to the

DWM-311's DATA1 port on the DWM-311.

4. Finally, connect the PoE injector's LAN-IN port

to an available Ethernet port on your end device

and plug in the injector's power cord into a

power outlet as shown in figure 5.

DIV

PRI

PoE Splitter

DC OUTL

AN OUT

PoE OUT

LAN IN

54V IN

End Device

Power In

Figure 7: Powering with a PoE injector

Note: The above case assumes you are using a D-Link

DPE-301GI 1-Port Gigabit PoE Injector and D-Link

DPS-301GS 1-Port Gigabit 30W PoE Splitter (both

sold separately). Other PoE configurations may

vary.

Connecting Devices

After the DWM-311 has been successfully installed,

the modem can be connected to the end device via

either of the following connection methods:

Over Ethernet

The Ethernet port can be connected to an end device.

Use a standard Category 5/5e/6 RJ-45 Ethernet cable

to connect the end device to the modem. The port

DWM-311

Connect DATA1 on the

DWM-311 to the Ethernet

port labeled PoE OUT on the

PoE injector. Connect the

Mini-USB port to the

splitter's DC OUT using the

included adaptor

PoE Injector

Connect a device to the

Ethernet port labeled LAN

IN on the PoE injector

Connect the power

adapter to the PoE injector

and a power outlet

will auto-negotiate to the highest possible port

speed based on the connected device. Note that the

DWM-311 supports a maximum transfer speed over

Ethernet of 100 Mbps.

Over USB 2.0

To connect the modem over USB, connect a micro-

USB cable (not included) to the port marked DATA2

on the back panel. Insert the other end of the

cable into a free USB port of the device you wish to

connect.

Note: The modem cannot accept power over micro-

USB, only over mini-USB through the port labelled

with the symbol.

Diagnostics and Advanced Settings

To access the Web UI of the modem, open a web

browser on a connected device and navigate

to 192.168.17.1 for Ethernet connected devices,

and 192.168.15.1 for USB 2.0 connected devices.

The default user name is admin and the default

password is admin.

After login, the UI displays an overview of the

modem's current status. Diagnostics and advanced

settings can be accessed by clicking the Diagnostics

button.