Connecting An S-Vhs Vcr; Connecting A Second Vcr To Record From The Tv - Samsung DynaFlat TX-P3076WH Owner's Instructions Manual

AA68-03388A-00_eng_Chapter2
I
N S TA L L AT I O N

Connecting an S-VHS VCR

Your TV can be connected to an S-Video signal from an S-VHS VCR. (This connection delivers
a better picture as compared to a standard VHS VCR.)
To begin, follow steps 1–3 in the previous
section to connect the antenna or cable
to your VCR and your TV.
Connect a set of audio cables between the
AUDIO OUT jacks on the VCR and the
AUDIO IN 1 jacks on the TV.
Connect an S-video cable between the
S-VIDEO OUT jack on the VCR and the
S-VIDEO jack on the TV.
An S-video cable is usually included with an S-VHS VCR. (If not, check your local
electronics store.)

Connecting a Second VCR to Record from the TV

Your TV can send out signals of its picture and sound to be recorded by a second VCR.
To do this, connect your second VCR as follows:
4/21/04 5:24 PM
1
2
3
1
Connect a set of audio cables between
the AUDIO OUT jacks on the TV and the
AUDIO IN jacks on the VCR. (The VCR
input jacks might be either on the front or
on back of the VCR.)
2
Connect a video cable between the
VIDEO OUT jack on the TV and the VIDEO
IN jack on the VCR.
Refer to your VCR' s instructions for more
information about how to record using
this kind of connection.
Page 19
TV Rear Panel
TV Rear Panel
19