Connecting A Vcr; Connecting An S-Vhs Vcr - Samsung TX-S2740X Owner's Instructions Manual

Connecting a VCR

These instructions assume that you have already connected your TV to an antenna or a cable TV system (according to the instructions
on pages 8-9). Skip step 1 if you have not yet connected to an antenna or a cable system.
VCR Rear Panel
5
Audio Cable (Not supplied)
2
4 Video Cable (Not supplied)
3
Antenna Cable (Not supplied)
➢
Each external input source device has a different back panel configuration.
➢
When connecting an external device, match the color of the connection terminal to the cable.
➢
Also, you can connect to "AV IN 2" on the side panel of TV.

Connecting an S-VHS VCR

Your Samsung TV can be connected to an S-Video signal from an S-VHS VCR.
(This connection delivers a better picture as compared to a standard VHS VCR.)
VCR Rear Panel
3 Audio Cable (Not supplied)
2 S-Video Cable (Not supplied)
1
Antenna Cable (Not supplied)
An S-Video cable is usually included with an S-VHS VCR. (If not, check your local electronics store.)
➢
Each external input source device has a different back panel configuration.
➢
When connecting an external device, match the color of the connection terminal to the cable.
All manuals and user guides at all-guides.com
ANT IN
TV Rear Panel
TV Side Panel
English-10
1. Unplug the cable or
antenna from the back of
the TV.
2. Connect the cable or
antenna to the ANT IN
terminal on the back of the
VCR.
3. Connect an Antenna
Cable between the ANT
OUT terminal on the
VCR and the ANT IN
terminal on the TV.
4. Connect a Video Cable
between the VIDEO OUT
jack on the VCR and the
AV IN 1 or AV IN 2
[VIDEO] jack on the TV.
5. Connect Audio Cables
between the AUDIO
OUT jacks on the VCR
and the AV IN 1 or AV IN
2 [L-AUDIO-R] jacks on
the TV.
➢
If you have a "mono"
(non-stereo) VCR, use a
Y-connector (not
supplied) to hook up to
the right and left audio
input jacks of the TV. If
your VCR is stereo, you
must connect two
cables.
1. To begin, follow steps
TV Rear Panel
1–3 in the previous
section to connect the
antenna or cable to your
VCR and your TV.
2. Connect an S-Video
Cable between the
S-VIDEO OUT jack on
the VCR and the AV IN 2
[S-VIDEO] jack on the
TV.
3. Connect Audio Cables
between the AUDIO
OUT jacks on the VCR
and the AV IN 2
[L AUDIO-R] jacks on
the TV.