Connecting An S-Vhs Vcr - Samsung PCJ533R Owner's Instructions Manual

I
N S TA L L AT I O N
3
Connect a coaxial cable
between the ANTENNA
OUT terminal on the
VCR and the antenna
terminal on the TV.
A coaxial cable is usually included with a VCR. (If not, check your local electronics
store).
4
Connect a set of audio
cables between the
AUDIO OUT jacks on the
VCR and the AUDIO
jacks on the TV.
If you have a "mono" (non-stereo) VCR, use the Y-connector (supplied) to hook up to
the left and right audio input jacks of the TV. If your VCR is stereo, you must connect
two cables.
5
Connect a video cable
between the VIDEO OUT
jack on the VCR and the
VIDEO jack on the TV.
Follow the instructions in "Viewing a VCR or Camcorder Tape" to view your VCR tape.

Connecting an S-VHS VCR

Your Samsung TV can be connected to an S-Video signal from an S-VHS VCR. (This
connection delivers a better picture as compared to a standard VHS VCR.)
1
To begin, follow steps
1–3 in the previous
section to connect the
antenna or cable to your
VCR and your TV.
2
Connect a set of audio
cables between the
AUDIO OUT jacks on the
VCR and the 2 AUDIO
INPUT jacks on the TV.
Make sure the jacks you are using are underneath the number "2."
VCR Rear Panel
AUDIO VIDEO
IN
OUT OUT
ANTENNA
L R
OUT
Coaxial Cable
VCR Rear Panel
AUDIO VIDEO
IN
OUT OUT
ANTENNA
L R
OUT
VCR Rear Panel
AUDIO VIDEO
IN
OUT OUT
ANTENNA
L R
OUT
VCR Rear Panel
AUDIO VIDEO
IN
OUT OUT
ANTENNA
L R
OUT
Coaxial Cable
VCR Rear Panel
AUDIO VIDEO
IN
OUT OUT
ANTENNA
L R
OUT
continued...
TV Rear Panel
Audio Cable
TV Rear Panel
Video Cable
TV Rear Panel
TV Rear Panel
Audio Cable
C
HAPTER
TV Rear Panel
2.5
T : I
WO NSTALLATION