AA68-03388A-00_eng_Chapter1
Y
N
O U R
Rear Panel Jacks
Use the rear panel jacks to connect an A/V component that will be connected continu-
ously, such as a VCR or a DVD player.
Your TV has several input jacks, so you can connect different A/V components simulta-
neously (i.e., a VCR and a DVD, 2 VCRs, etc.).
For more information on connecting equipment, see page 14~24.
Œ DVI (Digital Visual Interface)
´ AUDIO-VIDEO MONITOR
ˇÔ AUDIO INPUT1, 2, 3 jacks
¨ VIDEO INPUT1, 2, 3 jacks
ˆ DIGITAL VIDEO INPUT
4/21/04
5:25 PM
D
T V
E W
I G I TA L
AUDIO INPUT jacks
Receives the digital audio signals from AV devices.
OUTPUT jacks
Connect to the audio/video input jacks of a record-
ing VCR.
Connect to the audio output jacks of VCRs,
DVD players and similar devices.
Connect to the video output jacks of VCRs,
DVD players and similar devices (Three sets
are available: Video1, Video2 and Video3).
(Digital Visual Interface)
jack
Receives the digital signals from a Set-top Box.
Page 11
Ø S-VIDEO INPUT jack
Connect to S-VIDEO output jacks of an S-VHS VCR
or DVD player.
Note: In S-Video mode, Audio Output depends
what kind of audio input source is connected to
the side audio input jacks (AV1).
∏ UPGRADE PORT
For service only.
" OPTICAL OUTPUT jack
Connect to a Digital Audio component.
' ANTENNA terminals
Two independent cables or antennas can be con-
nected to these terminals. Use ANT A and ANT B
terminals to receive a signal from VHF/UHF anten-
nas or your cable system.
˝ COMPONENT1, 2
(480i, 480p, 720p, 1080i)
AUDIO/VIDEO INPUT jacks
Connect to the Audio & Video outputs of DVD or
DTV Set-Top-Box.
11