Read All Io Statuses; Link Multiple Modules; Io Operating Hours Counter; Digital Output Counter - CONTACLIP GSM-PRO2 Instruction Manual

9.6

Read all IO statuses

To retrieve the status of all IOs send: rall. The module answers: With the module name and the status of all IO's
and extensions.
To send the full IO status to an email address send: rall<email>.
9.7

Link multiple modules

It's possible to link multiple modules by SMS. By selecting the 'send only user defined text' in the IO
configuration it's possible to send the pre-defined messages to other modules.
For example: digital input 2 sends WDO11 on a rising flank to a second unit. This unit receives the message,
set's the digital. On the falling flank the first unit sends WDO10 to deactivate the digital output on the second
unit.
It is also possible to send an SMS to itself and activate digital outputs on reaction to digital inputs.
NOTE: The digital outputs cannot parse any messages. They only respond to their sender.
9.8

IO operating hours counter

The IO operating hours counter sums the total time the IO is in HI state. The counter can be turned on/off each
individual digital in- and output. The counted value can be added to the periodical message and 'RALL'.
Counters are limited to 17500 hours (+/- 2 years).
NOTE: make sure to keep all IO's in LO state when configuring the counters due to faults in starting time.
9.8.1

Digital output counter

To retrieve the counter value of an individual digital output, send: timedo1, where n is the number of the
requested digital output.
To retrieve the counter value of all digital outputs send: timedo0.
To reset the counter value of an individual digital output, send: clrtimedon, where n is the number of the
requested digital output. To reset all counter values of the digital outputs, send: clrtimedo0
9.8.2

Digital input counter

To retrieve the counter value of an individual digital input, send: timedin, where n is the number of the
requested digital input.
To retrieve the counter value of all digital inputs send: timedi0.
To reset the counter value of an individual digital input, send: clrtimedin, where n is the number of the
requested digital input. To reset all counter values of the digital inputs, send: clrtimedi0
- 25 -
GSM-PRO2