Electrical Installation - Wiring - Max G004 Manual

Electrical Installation - Wiring

This page covers the installation of transmitters with 5-pin, M12 style connectors only. For hazardous location devices
with 1/2" conduit connections, please refer to the EXInstall sheet.
Frequency Output Transmitters
4
3
5
1 2
Power (+5 to 26 Vdc)
Common
Pulse Output
Output Phase B (Quad only)
Case Ground
Current Sinking Wiring
(Model # 295-600-000 and versions ending with S/-)
A current sinking device uses the transmitter's transistor output to act as a
switch. A positive DC voltage must be applied to the transmitter's output pin
(#2). When the pulse output is triggered, this voltage will be grounded to zero
volts by the transmitter. Warning: Use a 5k ohm resistor to limit current if your
system does not have any other means to limit the current into the transmitter.
Voltage or Current Analog Transmitters
4 3
5
1 2
Power *
Common
Signal Output (+)
Signal Output (—)**
Case Ground
* Analog transmitters with part numbers 29X-XXX-000 or ending in A/- or C/- are 24Vdc power. Part numbers 29X-XXX-100 or ending in B/- or D/-
are 12Vdc power.
** To minimize signal noise, analog output transmitters are fully isolated. If your PLC does not ground the negative signal input, there is a risk of a
ground shift that could drive the signal out of the range of detection. To prevent this from occuring please consider installing a 10k pull
down resistor between Common and Signal Output (-).
Max Machinery, Inc. G-Series User Manual
(Models ending with P..N/- or Q..N/-)
Turck®
Connector
Mating Cable
PCA
Pin #
Wire Color
Label
V+ 1 Brown
Com 4 Black
Ph A 2 White
Ph B 5 Grey
Case 3 Blue
Turck®
Connector
Mating Cable
PCA
Pin #
Wire Color
Label
V+ 1 Brown
Com 4 Black
Sig 5 Grey
Ret 2 White
Case 3 Blue
© Copyright 2018
(Models ending with A/-, B/-, C/- or D/-)
Rev2018A
V+
PLC
V+
Digital
0V Input
Out
Turck Pin #2
Transmitter
10