Table of Contents
Advertisement
Chapter 5
Install the AADvance System
Install a 9110 Processor
Module
120
Do the following:
• Before inserting a new processor module, examine it for damage.
• The identification labels on the sides of the module will be hidden after
the module is installed. Therefore before installation make a record of
the location of the module and the details shown on the label.
• If you are installing more than one processor module make sure they all
have the same firmware build.
Installation
1. Examine the coding pegs on the 9100 processor base unit and make sure
they complement the sockets on the rear of the processor module:
2. Place the processor module on to the coding pegs. Make sure the slot on
the head of the module locking screw is vertical and then push the
module home until the connectors are fully mated.
3. Using a broad (9mm) flat blade screwdriver turn the module locking
screw clockwise to lock.
NOTE The locking screw acts as a power interlock device and must be locked or the
module will not boot up.
Rockwell Automation Publication ICSTT-RM448J-EN-P - April 2018
Advertisement
Table of Contents
