Endpoint Setup; Operation; Leds On Endpoint; Reset - Triax 383101 User Manual

5. Endpoint setup

Operation

Each endpoint has two RF ports, EoC + TV and TV out.
The EoC + TV port communicates using network (data) signals on 2-200 MHz and receives TV signals on
300-862 MHz.
The endpoint splits the signals into network data, accessible through ethernet and WiFi, and TV out.

LEDs on endpoint

Signal
No light: No network data connection to

the controller.
Flashing light: Communicating with the

controller.
Solid light: Network data connection to

controller established.
Colour Green: Good working connection.

Colour Orange/Yellow: Connection issues

(poor signal or authentication issues ).
Colour Red: Connection error (very poor

signal).
WiFi
No light: WiFi is turned off.

Flashing light: Indicates an error state.

Solid light: WiFi is turned on.


Reset

A paper clips or similar can be used to press the reset button on the endpoint.
This will trigger a reboot and remove the configuration data on the endpoint.
After start up the endpoint will automatically download the configuration from the controller, corresponding
to the group the endpoint is assigned to.

Mounting

For optimal WiFi coverage and for optimal cooling, always mount the Endpoint vertically on a wall as shown.
EN
Status
No light: Endpoint is not powered on

(main CPU not running).
Flashing light:

o
o
Solid light: Endpoint is powered on.

8
Ethernet over COAX
Slow (1s frequency):
Starting up or rebooting.
Fast (200ms frequency):
Configuration
synchronization or FW
updating.