Network - Triax 383101 User Manual

Network

Change of settings of the network infrastructure, including the coax data connection.
Management settings

Apart from the default controller management interface on ethernet port 1 (setup VLAN 10), it is possible
here to allow management access through an additional VLAN (ethernet port) of your choice.
Furthermore, you can configure IPv4 settings used for management.
 VLAN settings
This sub-page allows you to create any VLANs you need, which then can be configured on either WiFi SSIDs
or ethernet ports.
The default VLANs can be changed or they can be deleted, if you prefer to create your own. The Setup VLAN
cannot be deleted.
You can add a new VLAN by simply clicking 'Add'. Then type in the name you want and the VLAN number you
wish to use (any number in the range 2-4095 can be used. VLAN 0 and 1 are reserved).
Checking the 'Client isolation' will prevent any network traffic to flow between clients connected to this VLAN
in the EoC system. In such a VLAN the clients cannot see each other or interact unless this is done through
an external (Internet) server. For the client isolation to work correctly, please ensure that any network
infrastructure (routers and switches) connected to a client isolated VLAN of the EoC system also has a client
isolation feature.
If you are using more than one VLAN for Internet, any router in front of the controller is required to
have either different subnets configured for each VLAN and/or VLAN separation for the client
isolation to work properly.
WiFi settings

For WiFi radio settings see the "Endpoints settings" paragraph.
The WiFi settings allows to create multiple SSIDs to use on the endpoints.
The default SSIDs can be changed or deleted as needed, however the TriaxSetup_xxxx SSID cannot be
deleted.
The default SSIDs and their corresponding keys (passphrases) for authentication are listed below:
TriaxSetup_xxxx "SetupPasswordxxxx" (where "xxxx" are the last 4 characters of the controller

management interface MAC address)
Guest: "guestpassphrase"

Private: "privatepassphrase"

You can add a new SSID by simply clicking 'Add new'. This allows you to create a new SSID with 2.4 and/or
5.0 GHz radios and the VLAN you prefer to use and the encryption needed.
If you choose to use encryption, you will need to enter a key (passphrase) for this SSID.
Ethernet settings

These settings allows you to configure the specific ethernet ports.
The controller port 1 settings cannot be changed, as this is by default a management port for the setup VLAN
(10).
The other controller ethernet ports can be configured as needed.
The controller ethernet is configured individually per port, and the endpoint ethernet port settings are
configured as a table of rules.
Each rule can be assigned to an endpoint configuration group (see "Group settings").
This means that all endpoints within a certain configuration group will all have the same ethernet rule
settings.
EN
NOTE
10
Ethernet over COAX