Table of Contents
Advertisement
Ethernet over COAX
6. Controller interface
It is possible to access the web interface by connecting a PC via ethernet to port 1 on the controller. Open a
browser and type in
http://setup.eoc
admin/admin, but is usually changed through the configuration wizard.
After changing any settings, you must press the Save & Apply button, before the specific settings
takes effect on the endpoint or controller.
In the top right corner of the controller interface you will see a red disk if there are settings that have
been changed but not applied yet. If the disk is green all settings have been saved and applied.
Changes done in the configuration wizard are automatically saved and applied, after clicking "Finish"
on the last page
Configuration wizard
When accessing the controller interface for the first time, the configuration wizard welcome page will be
shown. In case this is not automatically shown, it can be accessed at:
At the configuration wizard welcome page you have the possibility to choose either:
Configuration wizard: this will take you through the most common configuration options:
Administrator account settings
Checking internet connection
Firmware update
Date & time settings
Restore/import configuration from backup
G.hn filters
WiFi settings
Configurations groups
Configure manually: skip the configuration wizard
After completion of the configuration; the wizard will not automatically be started
again.
Status
The system status page gives you an overview of the controller and the endpoints connected to the
controller.
The WiFi Clients status will show you which clients (if any) are connected to the WiFi of the endpoints.
Ethernet clients status will show you which clients (if any) are connected to an ethernet port on the
endpoints.
and type in the admin username and password. By default this is
NOTE
(filter settings, filter setup ?)
NOTE
9
http://setup.eoc/config_wizard
EN
Advertisement
Table of Contents
