Standard Configuration Groups; Initial Setup; Private Only; Guest Only - Triax 383101 User Manual

2. Standard configuration groups

The EoC controller and the endpoint comes with standard configuration groups. These can be used if you do
not need any further WiFi SSIDs or configuration of ethernet ports.
The standard configuration can be used in any
network where there is a need for
1. A private network, where clients must be
able to communicate with each other.
This could be printing from a PC to a
network printer or a PC needs to get files
from a local server etc.
2. A public guest network, where clients
cannot see each other (client isolation
active). This allows for a public WiFi,
where guests cannot access others
devices in the EoC system.
3.
IP TV distribution
All inbound traffic on the ethernet ports are tagged with the appropriate VLAN.
The controller is set up with the four standard configuration groups (Setup, Private, Guest, Guest & Private) as
a default.
A configuration group is a specific configuration used for the endpoints. A configuration group defines how
an endpoint is set up with WiFi, VLANs, port tagging.
This allows for simple configuration of an endpoint by assigning it to a group instead of applying all settings
individually.
The four configuration groups are described below

Initial Setup

This is a group that is used only for initial setup of the
endpoint.
All new endpoints will by default be configured with
this group.
An endpoint in this group broadcasts the
TriaxSetup_xxxx WiFi SSID, which allows you to
connect to the controller to configure an endpoint.
It sets the endpoint up as follows:
VLAN 10 on etherned port (Use to access

the controller interface
SSID: TriaxSetup_xxxx (VLAN 10)


Guest only

This is a group for a public guest network. It sets up
the endpoint as follows:
VLAN 80 on ethernet port (Mainly used

for IP TV – but basically a private VLAN)
SSID: Guest (VLAN 100, with client

isolation)
EN
The standard configuration on the controller is as
follows
Ethernet port 1: Fixed for management

port (VLAN 10)
Ethernet port 2: Private network (VLAN

50)
Ethernet port 3: Guest network (VLAN

100)
Ethernet port 4 : IP TV (VLAN 80)


Private only

This is a group for a private VLAN. It sets up the
endpoint as follows:
VLAN 80 on ethernet port (Mainly used

for IP TV – but basically a private
VLAN)
SSID: Private (VLAN 50)


Guest and Private

This is used for an endpoint which serves both
private and public WiFi. It sets up the endpoint as
follows:
VLAN 80 on ethernet port (Mainly used

for IP TV – but basically a private VLAN)
SSID: Private (VLAN 50)

SSID: Guest (VLAN 100, with client

isolation)
6
Ethernet over COAX