D-Link DGS-3630-28TC Quick Installation Manual page 11

Set the terminal emulation software as follows:
 Select the serial port that belongs to the virtual COM port.
 Set the data rate to 115200 baud.
 Set the data format to 8 data bits, 1 stop bit, and no parity.
 Set flow control to none.
To be able to view the boot procedure, the Switch needs to be rebooted. The simplest way,
at this stage, to reboot the Switch is to unplug and re-insert the power cable from and into
the power receptacle on the back of the Switch. After correctly configuring the terminal
settings and re-inserting the power cable, the boot procedure will appear in the terminal.
Figure 15 — Device Manager
Figure 16 — COM Port Configuration
11