4. Additional Information - LogTag Recorders TRID30-7 User Manual

4. ADDITIONAL INFORMATION

Reviewing day statistics
The Logger will display up to 30 days of max/min/duration and alarm statistics. If the Logger is configured
to record longer than 30 days (or continuously) then the day statistics will contain up to the latest 30 days.
To review the day statistics, press the 'REVIEW/MARK' button. Each press of the button will step through
the Max and Min temperatures for each day starting with today and moving backwards
through the days (displayed day will flash). Any button activity during recording will
place an inspection mark in the next reading of logged data which will be displayed
when the data is downloaded.
Following are some examples:
Pressing the 'REVIEW/MARK' button displays current days 'MAX' statistic. The
'TODAY' segment flashes and 'DAY 00' is shown to indicate the 'TODAY' selection.
The selected day (today) does not have any recordings outside the pre-set limits.
Pressing the 'REVIEW/MARK' button again displays the days 'MIN' statistic. The 'MIN'
statistic is not below the limit and did not trigger an alarm.
Pressing the 'REVIEW/MARK' button again displays the next previous days 'MAX'
statistic. The 'MAX' in this example is above the upper limit and the 'ALARM' was
triggered for a duration of 10 hours and 11 minutes.
Pressing the 'review button' again displays the
days 'MIN' statistic. The 'MIN' statistic is not below the limit and did not trigger an alarm.
If less than 30 days of recordings have been collected, the day marker only advances as far as there is
data available. After the last day for which statistics have been collected is displayed, the next press of
the 'START/CLEAR/STOP' button rolls the summary back to the statistic for 'TODAY'.
Display overview