DELTA DORE TYBOX 21 Quick Setup Manual

TYBOX 21 Quick Setup Guide (also for TYBOX 23 & TYBOX 24): FOR INSTALLER & USER
Before you begin please note the following & for any technical queries please contact your area representative through your merchant:
•
The wireless models are PRE-ASSOCIATED, simply connect the receiver and it is ready to operate.
•
Remove front cover by hand to reveal the battery housing and discard the blue tab to activate.
•
The unit is battery powered and has volt free & 230v contacts. In most cases wiring is directly to the thermostat input in the boiler
via the RT 24V input. Refer to the wiring diagrams below or boiler documentation for more information (For Tybox24 see receiver);
1. Set the Temperatures for the Thermostat
On the face of the thermostat you will find three buttons. MODE + & -. All functions are performed with these buttons.
a. Option 1: simple increase & decrease
Should you wish to simply operate the unit to increase and decrease temperature (or if you are using it in conjunction with a time clock
and only require one temperature) then press MODE until you are in the
and down to your preferred temp (recommended: 19°C)
b. Option 2: three temperature options
Should you require a little more control then you can input 3 independent temperatures and switch to the preferred one by simply
pressing MODE to inform the boiler what temperature you want;
On/Day/Comfort –
Off/Night/Setback –
Off/Holiday/Frost Protection –
2. Advanced Menus
To access the advance menu press and hold MODE for 10 seconds whilst the display is in
time per advanced option.
There are 3/4 advanced options and they are as follows;
•
The menu, Set point and room temp display.
Displays the target (Set Point) temperature, room temperature will appear on display before an adjustment is made FACTORY SETTING – 01
Displays the room temperature, target (Set Point) temperature will appear while adjustment is being made – 00
To change between 00 and 01 simply press the + button
•
The 0.0°C menu
This menu enables the user to fix any disparity between the temperature the unit is measuring and the actual room temperature (if any). These
parameters can be adjusted up to +/- 5.0°C by simply using the + & - buttons.
FACTORY SETTING 0.0°C
recommended: 19°C
recommended: 14°C
recommended: 8°C
menu. From here use + & - to adjust the temperature up
, then to navigate through the menu you simply press MODE one