Optional Accessories - DeWalt DWV012 Instruction Manual

Heavy-duty dust extractor vacuum

Hide thumbs Also See for DWV012:

Instruction manual (45 pages)

Instruction manual (45 pages)

Table Of Contents

Table of Contents

Available languages

Enlarged version

English

4. Inspect filters for wear, tears or other damage.

nOTE: If there is any doubt on the condition of the

filters they MUST be replaced. DO NOT continue use if

filters are damaged.

WARNING: Never use compressed air or a brush to

clean filters, otherwise damage to the filter membrane

will occur which will allow dust to pass through the

filter. If needed, rinse with room temperature water

and let air dry. Cleaning of the filters is typically

unnecessary. Even if the filter is covered with dust,

the automatic filter cleaning system will maintain

maximum performance and continue to function. If

visual damage to the filter membrane exists, replace

filters. Filters typically last between six and twelve

months, depending on use and care.

To Install Filters

1. Ensure filter seal

is in place and is secure

2. Line up filter threads

using moderate force, turn filter clockwise until tight.

nOTE: Use care to not damage filter material.

3. Place the vacuum head

secure it by closing the canister latches

Fig. K

Cleaning

WARNING: Using a damp cloth, clean dust from

air vents at least once a week. Wear proper ANSI

Z87.1 (CAN/CSA Z94.3) eye protection and proper

respiratory protection as required by OSHA or

other governmental/provincial institutions for the

application being performed.

WARNING: Never use solvents or other harsh

chemicals for cleaning the non-metallic parts of

the tool. These chemicals may weaken the plastic

materials used in these parts. Use a cloth dampened

only with water and mild soap. Never let any liquid

get inside the tool; never immerse any part of the tool

into a liquid.

Storage (Fig. L)

1. Empty the canister, refer to To Empty Canister

under Operation.

2. Clean the vacuum inside and outside.

3. Clean or replace filters, refer to Filters.

to vacuum head threads and

onto the container and

4. Store the suction hose and the power cord as shown in

the illustration. Place the unit in a dry room and secure it

from unauthorized use.

nOTE: Plug inlet plug

inside canister when suction hose is removed. You

can also attach the ends of the hose together and lock

together with the twist-lock end.

Fig. L

Accessories

WARNING: Since accessories, other than those

offered by D

WALT, have not been tested with this

product, use of such accessories with this tool could be

hazardous. To reduce the risk of injury, only D

recommended accessories should be used with

this product.

Recommended accessories for use with your tool

are available at extra cost from your local dealer or

authorized service center. If you need assistance in

locating any accessory, please contact D

Tool Co., 701 East Joppa Road, Towson, MD 21286, call

1-800-4-D

WALT (1-800-433-9258) or visit our website:

www.dewalt.com.