Troubleshooting; Optional Accessories; Protecting The Environment - DeWalt DWH051 Manual

WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing
set-ups or when making repairs.
Be sure the trigger switch is in the OFF
position. An accidental start-up can
cause injury.

TROUBLESHOOTING

FAULT POSSIBLE CAUSE
Excessive dust extractor
dust is full
emission
suction channel is
blocked
The chisel is
extended more
than 125 mm
Dust the dust extraction
Extraction system is not
System assembled
does not correctly
attach to
adaptor and tool
hammer
holder are oily or
greasy
the locking latch is
damaged
wrong adaptor
being used
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.

Optional Accessories

Consult your dealer for further information on the
appropriate accessories.
REMEDY
empty the dust

Protecting the Environment

extractor
clean the suction
channel
use a shorter
chisel or a longer
dust shroud
Should you find one day that your D
refer to Assembly
needs replacement, or if it is of no further use to you,
and Adjustment
do not dispose of it with household waste. Make this
section
product available for separate collection.
remove oil and
grease with a
clean cloth
replace locking
latch
select the correct
adaptor, refer to
Local regulations may provide for separate collection
figure 1
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
D WALT provides a facility for the collection and
E
recycling of D
reached the end of their working life. To take
advantage of this service please return your product
to any authorised repair agent who will collect them
on our behalf.
You can check the location of your nearest
authorised repair agent by contacting your local
D WALT office at the address indicated in this
E
manual. Alternatively, a list of authorised D
repair agents and full details of our after-sales
service and contacts are available on the Internet at:
www.2helpU.com.
WARNING: Since accessories, other
than those offered by D WALT, have
E
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT recommended
E
accessories should be used with this
product.
Separate collection. This product must
not be disposed of with normal
household waste.
WALT product
E
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
WALT products once they have
E
EN G LI SH
WALT
E
23