LAUNCH TECH X-431 Torque User Manual page 80

A. If it is the first time you have operated this printer, please proceed the
following:
2. For initial use, you are suggested to reset the printer: Press and hold [MODE]
& [FEED] for 8 seconds, the following resetting command will be printed out:
at + default = 1
ok
at + reboot = 1
rebooting...
1. Tap "Reset" to configure Wi-Fi printer.
Step 1: Connect the printer:
Tap "Scan" to start scanning and select the desired printer hotspot named
with X-431PRINTER-XXXX (XXXX stands for 4 characters), and then tap
"Connect" to enter Step 2.
Step 2: Join the Wi-Fi printer into LAN:
Tap "Scan" to select the desired local Wi-Fi network from the list, and type in
the security password (If it is an open network, password is not required), and
then tap "Confirm".
4. Once the Wi-Fi network of the printer is connected and the printer is found,
X-431 Torque User Manual
Fig. 9-9
Fig. 9-10
72