Maintenance - Caple ST852 Instruction Manual

Built-under hood

Hide thumbs Also See for ST852:

Instruction manual (16 pages)

Table Of Contents

Maintenance

How to remove the oil tank

- After having removed the grease filters and

eventually the charcoal filters, please hold the oil

tank up by one hand and loosen the three handles

- An accurate maintenance helps guarantee good

by the other hand as showed in (fig.8). Then let the

functioning and long-lasting performance.

tank slide downwards taking care in order to avoid

spilling any oil.

- Particular care is required for the grease filter

panel. It can be removed by pushing its handle

How to clean the extractor

toward the back-side of the cooker hood and

- To clean the appliance itself tepid water and

pulling the filter downwards to unfasten it from

neutral detergents are recommended, abrasive

its slot (Fig.3).

products should be avoided to prevent damage to

To insert the filter just perform the opposite

the finish. For steel parts specialsed detergents can

operation.

be used (please follow the instructions indicated on

After 30 hours working, the push button

the product itself to obtain the desired results).

control panel will signal the saturation of the

grease filter by illuminating all the buttons. Press

- Warning! To uninstall the appliance from the

the timer button to reset

cabinet, remove the fixing screws (fig. 6) using a

The grease filter needs cleaning by regular

screwdriver, then remove the grease filters (fig.3)

hand-washing or in your dishwasher at least

and the charcoal filters if they have been fitted (fig. 7).

every two months or more depending on its use.

Push on the small handle of the springs, which are

- In case the appliance is used in its recirculating

inside the built-in unit, with the necessary force to

mode, the active charcoal filter (Fig.7) needs to be

unhook the appliance from the cabinet.

periodically replaced. The charcoal filter can be

removed by removing the grease filter first (Fig.3),

* NOTE: If the supply cord is damaged, it must be

and by pulling its special plastic tongue until it is

replaced by the manufacturer, its sevice agent or a

unfastened from its slot. Re-insert the charcoal

similarly qualified person in order to avoid a

filter by operating in the opposite way.

hazard. Contact Caple Service on 0844 800 3830

or email service@caple.co.uk

The charcoal filter needs replacing depending on

the use, but at least every six months.

Replacement of the LED light bar:

Disconnect the extractor from the electrical supply.

Using an appropriate tool, remove the LED bar

from its seat (refer to Fig. 10), disconnect it from

the appliance using the appropriate connector then

substitute it with a LED bar with same

characteristics and install the light bar back into its

seat .