Tying The Unit Down; Lifting The Unit - Generac Power Systems MAGNUM MLT4060MVD Owner's Manual

A
Figure 3-12. Tandem Tow Hitch

Tying the Unit Down

When securing the unit for transportation, verify the
equipment being used to fasten the unit is in good
condition and has sufficient strength to hold the unit in
place during transport.
See Figure 3-13. Use the tie-down points (C) as shown.
Figure 3-13. Tie-Down Points
A
B
Owner's Manual for MLT4060MVD Light Tower
C
004036
Figure 3-14. Lift Points

Lifting the Unit

WARNING
Personal Injury. Do not use lifting eye if there
are signs of damage or corrosion. Doing so
could result in death, serious injury, or
property damage.
WARNING
Personal Injury. Do not use lifting eye other
than as directed. Doing so could result in
death, serious injury, or property damage.
Follow these steps to prepare the unit for lifting:
1. See Figure 3-14. Verify the equipment being used
to lift the unit (A) is in good condition and has suffi-
cient capacity. For approximate weights, refer to
Specifications.
2. Close and lock all hoods and doors.
3. See Figure 3-14. Stow the mast and lights in the
travel position as shown.
4. Always remain aware of people and objects around
the unit while preparing, maneuvering, and lifting
the unit.
When lifting the unit, attach any slings, chains or
•
hooks directly to the central lift point (A).
Use the forklift pockets (B) with care. Lift only from
•
the side or the rear. Avoid approaching the unit at
an angle, as this can permanently damage the
forklift pockets, tires, or cabinet. Verify the forklift
tines are clear of any obstructions before lifting.
Operation
(000433)
(000434)
37