Omega MWTC SERIES User Manual page 38

4
Connector Operation
Figure 4-12. Send Settings To Transmitter Screen
Congratulations! You have successfully programmed your connector transmitter.
After your unit has been programmed click the "Finish" button to close the utility
program or click the "Start" button to begin setting up a second unit. You can now
disconnect your connector transmitter from the programming cable. Press the
"Setup" button on the connector/transmitter one time to exit the "Setup" mode
NOTE:
Here are the default settings for the MWTC-D Wireless Transmitter/Logger
Recording / sampling interval = 5 seconds
Start Logging at = Power Up
Engineering unit = Deg F
Recording Selection = Process and Ambient Temperature
Mode of operation = Wireless Only
NOTE:
When operating the MWTC-D for the first time, or every time the battery is replaced,
you need to configure the unit using the End Device Configuration Wizard program.
It allows you to set up logging parameters such as current time & date, recording
interval, Start Logging Mode, Recording selection, and mode of operation.
The current Time & Date is lost when the battery is removed.
4-9