One for All URC-9040 Instruction Manual page 12

Pc media remote
Hide thumbs Also See for URC-9040:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
The URC-9040 comes with a complete library of pre-programmed codes. After you have set up
the URC-9040 for your device, you may find that there are one or more keys that you had
on your original remote, which do not have a place on the URC-9040 keypad.
As a convenience, the URC-9040 offers a special Learning feature that
allows you to copy any function from your original remote control onto the
keypad of the URC-9040.
Before you start:
- Make sure your original remote control is working correctly.
- Make sure neither your URC-9040, nor your original remote control is pointing at your device.
Example: To copy the "mono/stereo" function from your original TV
remote onto the "LAST" key of your URC-9040.
1.
Place both remote controls (the URC-9040 and your original) on a flat surface.
Make sure the ends which you normally point at your device are
facing each other. Keep the remotes at a distance of 2 to 5 cm.
2.
3.
4.
5.
6.
7.
If you want to copy other functions within the same mode, simply repeat
steps 5 and 6 pressing the next key you want to copy by learning.
If you want to copy other functions to a different mode, then repeat from
step 4 onwards and press the applicable mode key.
8.
9.
Learning is mode specific. To access your learned function, press the appropriate device key first.
10
The Learning Feature
Press and hold down REWIND + FASTFORWARD
simultaneously until the URC-9040's LED (red light)
blinks twice (the LED will blink once and then twice).
Press 9 7 5 (the LED will blink twice).
Press the device key (on the URC-9040 remote) to select the mode
to which you want to copy the learned function (example: TV key).
Press the key (on the URC-9040 remote) where you want to place
the learned function (example: LAST key). The LED will flash rapidly.
Press and hold the key (on your original remote) that you want
to copy until the LED on the URC-9040 blinks twice (example:
"mono/stereo" key).
To exit the learning mode, press and hold OK until the LED blinks twice.
WWW.ONEFORALL.COM

Advertisement

Table of Contents
loading

Table of Contents