Elcometer PTG6 User Manual page 6

4 GETTING STARTED (continued)
A transducer adaptor is available which enables other Elcometer
'non-intelligent', single element delay line transducers and other
manufacturers' transducers, to be used with the Elcometer PTG
product range - see Section 16.5 'Transducer Adaptor' on page 31.
4.3 SELECTING YOUR LANGUAGE
1 Press and hold the ON/OFF button until the Elcometer logo is
displayed.
2 Press Menu/Setup/Language and select your language using
é ê
the softkeys.
3 Follow the on screen menus.
To access the language menu when in a foreign language:
1 Switch the gauge OFF.
2 Press and hold the left softkey and switch the gauge ON.
3 Select your language using the
4.4 SCREEN SETTINGS
A number of screen settings can be defined by the user via
Menu/Setup/Screen Settings including:
Screen Brightness; This can be set to 'Manual' or 'Auto' - the
Ÿ
brightness is adjusted automatically using the gauge's ambient
light sensor.
Screen Timeout; The display will dim if inactive for more than
Ÿ
15 seconds and will go 'black' if inactive for the period defined.
Press any key or tap the gauge to awaken it. The gauge can
also be set to switch off automatically after a user defined
period of inactivity via Menu/Setup/Gauge Auto Off. The
default setting is 5 minutes.
4.5 SETTING UP THE READING DISPLAY - PTG8
The colour LCD display is split into two halves; Top Display and
Bottom Display. The user can define what information is displayed
in each half including; Readings, Selected Statistics, Run Chart, Bar
Graph, Readings & Differential and B-Scan.
a
Not available in 'Scan Mode' - see Section 9.3 'Taking a Reading in Scan Mode' on page 20.
5
R
é ê
softkeys.
a
www.elcometer.com