Table of Contents
Advertisement
- In addition place the radio equipment Ex-PMR 500 in the charging case.
- The red LED on the device indicates that the accu is being charged.
-
For conservational charging, the green LED shines.
Advice: The charging socket is deactivated on the side of the equipment.
Accu change
Only the Ex accumulator module Type AM 500 may be used.
- Remove the equipment from the hazardous area
- Open the leather case and remove the Ex PMR 500
- Push the lock LOCK to the front of the device
- Place your thumb on the lid of the accu pack and press and remove downwards.
-
Remove the pack from the accu area and carefully remove the plug.
-
Warning: Do not pull on the cable!
- Insert a substitute accu and connect.
-
Pay attention to a safe engagement of the six pin plug!
- Seal the accu area with a lid, afterwards, the accu area must be secured with
-
the lock bolt LOCK.
- Secure the Ex PMR 500 in a leather case and seal completely.
-
Warning: Do not carry the substitute accu in the hazardous area!
Accu care
- Before use, the accu should be charged completely.
- Ensure that the maximal capacity of the accu is reached according to approximately
-
6 charging and discharging cycles.
- Since the efficiency of the accu decreases in the course of time, one should
-
occasionally discharge it completely so that the full capacity can be maintained.
- In addition the equipment can be left on until it turns itself off. The accu "AM500" must
-
be completely charged outside of the hazardous area.
Safety advice
- Do not drop the accu pack, do not damage, do not dismantle and do not
-
expose to unauthorized temperatures (-20 to +50 deg C)!
- Only charge the pack as described in the operating instructions!
- Never leave a discharged pack for a long time in unused equipment!
- Do not store the pack for longer than 6 months without discharging and
-
recharging in the meantime!
- Under no circumstances must one throw the accu into an open fire or into
-
domestic rubbish!
8
Advertisement
Table of Contents
