Ecom Instruments Ex-PMR 500 Instruction Manual page 25

Pilot procedures, CTCSS – general reception and transmission tones
- Hold button F and simultaneously press the TS button – indicator CTCSS?
- Press the MO/Fr/Ch button (after work, indicator CC 67.0)
- With the UP L or DOWN M buttons, select the desired pilot frequencies
(see table p. 25)
- Press the PTT button to confirm selection
The small indicator on the display, bottom right, shows the tone number.
- The pilot procedures can be activated with the F and TO buttons, but take care
that your partner station uses the same pilots (indicator TSQ).
Pilot procedures, CTCSS – different receiving and transmitting tones
- Switch your radio to the frequency indicator.
- Hold button F and simultaneously press button TS (ind. CTCSS?)
- Press the MO/Fr/Ch button(after work; ind. CC 67.0)
- Hold the F button and simultaneously press the UP L button (ind. Rc 67.0)
- Select the desired pilot receiving frequency using the DOWN M or UP L buttons.
- Hold the F button and simultaneously press the UP L button (ind. tc 67.0)
- Select the desired pilot transmitting frequency by using the UP L or DOWN M
buttons (see table p.25)
- Press the PTT button to confirm selection
The tone number will be shown for reception.
- Activate the pilot procedures by using the TO button but take care that the
receiving tone of the partner stations are programmed to the transmission tone
of the equipment and vice versa (ind. TSQ).
24