Inateck BR1008 Instruction Manual page 6

3) Place your Bluetooth audio receiving devices like earphones or
speakers closely to the BR1008. After approximately 30 seconds,
pairing will be completed. The BR1008 LED indicator will turn solid
blue.
4) Connect the BR1008 to your audio output devices like TV through a
3.5mm audio cable.
Note:
a. BR1008 will enter pairing mode automatically when powered on for
the first time.
b. BR1008 can only automatically re-pair to the 4 most recently
connected devices.
2. Pair with two devices at the same time
In TX mode, BR1008 is able to pair with two Bluetooth stereo earphones/
speakers at the same time. And both can play music at the same time.
1) Follow the previous instructions in the "Pairing" section to pair
the BR1008 with your first device. Turn off your first device after
successfully pairing it with the BR1008.
2) Tap the Multifunction Button twice to pair and connect to your
second device. Turn off the BR1008 after successfully pairing it with
your second device.
3) Turn on your first device and wait for 10 to 20 seconds. Both of your
devices are now ready for pairing. Turn on the BR1008, the devices
will automatically connect in. The BR1008 LED indicator will turn solid
green.
Note:
a. When the BR1008 connects two bluetooth receivers simultaneously
via aptX Low latency or aptX HD CODEC under TX mode, scenarios
like transmission stalling or noises are possible. If there's such
problem, please keep your bluetooth receivers on and reboot the
BR1008 to get rid of it.
b. Please turn off the BR1008 and restart it to re-pair if two devices
cannot play music at the same time. If the problem still exists after
5
repeating the whole steps above, please contact Inateck Support at:
support@inateck.com.