Table of Contents
Advertisement
9. Novell NetWare Driver Installation
1
At the MS-DOS prompt for CD-ROM installation, change directories
to where the installation files are located.e.g., d:\ <ENTER>
2
Type INSTALL <ENTER> to initialize the installation routine
3
Select installation Language. <ENTER>.
4
Select NetWare Server Installation <ENTER>
5
Select product type <ENTER>
6
Select installation type. <ENTER>
7
Enter server name when prompted <ENTER>
At this point the boot files will be copied to the hard drive.
8
After the files are finished being copied you may encounter the follow-
ing message:
Install found the following hardware but found more than one
driver supporting this hardware
PCI.XXXX.XXXX.XXXX.XXXX.XX
Press <Enter> for a list of drivers to choose
From or <F3> to continue without selecting
Press <F3> to continue. Repeat if this screen is shown again.
9
At the Server Driver Summary Screen choose Select/ Edit Disk or
LAN Drivers
10 Highlight Disk CD-ROM Drivers and press <Enter>
11 Press INS followed by F3
12 Place the PCI-SIU2 DRIVER DISK 1 in drive A: and press <Enter>
13 Highlight INIA100.HAM and press <Enter>
14 Highlight Select/Modify Driver Parameters
15 Enter slot number followed by F10
16 Highlight Save parameters and continue and press <Enter>
This will load the HAM driver. If a DSK driver is required or an updated HAM
driver is needed it is recommended that you complete the installation and use
NetWare's INSTALL utility to update/change the driver.
58
ASUS PCI-SIU2 User's Manual
Advertisement
Table of Contents
