HySecurity WedgeSmart DCS Installation Instructions Manual page 9

Theft Prevention: Prevent Unauthorized Exit
For theft prevention applications, use site scenarios similar to the illustrations shown on this page.
T F : S
RAFFIC LOW
To configure loops, refer to chart below and to the Programming and
Operations Manual.
Installing Loop C, 2 ft from the edge of hinge Installing Loop C, 2 ft from the edge of hinge Installing Loop C, 2 ft from the edge of hinge
plate allows a standard vehicle to bridge and
trigger both loops which, when cleared,
activates automatic closure.
2 feet (61 cm)
Loop C
Attack
3 ft (91 cm)
Direction
NOTICE: Deviating from
the 3 ft mark will:
• Increase interference from
the moving wedge plate
Loop B
• Reduce the ability to
The B loop (CLD) must be
activate automatic closure.
located on the barrier arm side.
6 ft minimum (183 cm) 6 ft minimum (183 cm) 6 ft minimum (183 cm)
To help mitigate
automobiles from
tailgating, maintain
4 foot distance
between loops.
If frequented by 4 ft min. 4 ft min. 4 ft min.
Loop D
high bed vehicles, (121 cm) (121 cm) (121 cm)
move loops closer
together.
WedgeSmart DC: Loop Layouts
---> P
ECURE UBLIC
Site Considerations
• Types of vehicles using the facility
• Clearance considerations
• Grade of ingress and egress
• Pad mount: Grade level or Recessed
• Grounding requirements
• Use of auto close feature
• Loops: A, B, C, D
• Access control
2 to 4 foot between loop and
edge of roadway (61 to 122 cm)
Use fixed bollards to direct
flow of traffic and protect front
and back of chassis.
Loop HY-5A SDC Input
ID Connection Connection:
OUTSIDE (Arming) OUT OBS
A *
OBSTRUCTION LOOP
CENTER LOOP CENTER
B
INSIDE (Arming) IN OBS LOOP
C
OBSTRUCTION
EXIT LOOP EXIT LOOP
D
(optional)
Requires 2 channel box detector. Connect to Emer Open and
E1
+24V on the Wedge Smart DC Controller (SDC). Configure
Installer Menu on the Wedge SDC: Set OC to 1. Emergency Close
E2
triggers when vehicles detected crossing from E2 to E1 loop.
*NOTE: Arming loop does not affect operation.
WedgeSmart DC Installation & Assembly - Loop Layouts
T F : P
RAFFIC LOW UBLIC
Traffic Flow
Loop A Loop C
Traffic Flow
Installer Menu
Settings
OALD, OOLD, OR Loop A
CLD, CR, CP
IALD, OALD, IR
ELD, DT, EB, CB
T
---> S E
ECURE WITH
Attack
Loop B
Direction
Emergency Close when E2 to E1
To connect and configure
Emergency Close, refer
to chart below.
Loop C
Attack
Direction
F : B -
RAFFIC LOW I DIRECTIONAL
C
MERGENCY LOSE
Loop Loop
E1 E2
OC 1 (ENABLED)
EMERGENCY CLOSE
OPEN CLOSE STOP MENU RESET
PREV NEXT SELECT
Loop B Loop D
Traffic Flow
MX3572-01 Rev. A Page 8