Related Manuals for HySecurity WedgeSmart DCS
Summary of Contents for HySecurity WedgeSmart DCS
- Page 1 Smart Wedge Installation Instructions Models WedgeSmart DC WedgeSmart DCS (Solar) Surface mount parking wedge with electromechanical barrier arm operator and Smart DC Controller MX3762-01...
- Page 2 WedgeSmart DC: Plan Site Design Read & Plan Determine Wedge Plate Location 9 ft lane = 123" (312 cm) 10 ft lane = 135” (343 cm) For alignment purposes, use the chassis Read and follow the Important Safety Information provided in the Programming and Operations 12 ft lane = 159“...
- Page 3 WedgeSmart DC: Install Foundation Tools Required Road surface level Š Forklift, crane or other heavy lifting equipment Consider vehicle clearance (semi truck Š Lifting straps rated to minimum of 4000 lbs and car hauler rigs) Š Lifting hooks or D connectors and road surface grade Š...
- Page 4 WedgeSmart DC: Drill & Set Anchors IMPORTANT: Vacuum all concrete dust from the anchor holes. Verify conduit aligns with chassis template window. If not, shift both wedge plate and CAUTION template positions to fit. Position equipment on the anchor holes. Add epoxy and anchors. Allow 12 hours for epoxy to cure.
- Page 5 Using a Chain steel bolt at this connection may damage the gearbox and chassis and void the HySecurity warranty. 5. Connect the one wire lead to the 24VDC power Controller •...
- Page 6 When AC power is lost, rate of RED blinking LED slows down. Not lit = AC power lost. Pressing SHOW LED’s button indicates the display and a HySecurity gate status appears. which inputs, if any are active At this point, the limits (target home positions) are established.
- Page 7 WedgeSmart DC: Complete the Install Configure the AL (Arm Lights) settings. Be sure to Ground the Operator RAFFIC IGHT PTION Check that the arm lights blink while the arm cycles and An additional traffic light can be mounted on the chassis and is searches for the target home position.
- Page 8 WedgeSmart DC: Loop Layouts Threat Protection: Prevent Unauthorized Entry ---> S For threat protection applications, use site scenarios similar to the illustrations shown on this page. RAFFIC UBLIC ECURE ---> P RAFFIC ECURE UBLIC 2 to 4 foot between loop and edge of roadway (61 to 122 cm) Traffic Flow NOTICE: Deviating...
- Page 9 WedgeSmart DC: Loop Layouts Theft Prevention: Prevent Unauthorized Exit For theft prevention applications, use site scenarios similar to the illustrations shown on this page. ---> S RAFFIC UBLIC ECURE WITH MERGENCY LOSE ---> P RAFFIC ECURE UBLIC Traffic Flow Site Considerations To configure loops, refer to chart below and to the Programming and Operations Manual.
- Page 10 1-800-236-0112 5100 West Brown Deer Road Distributed by www.tapconet.com Brown Deer, WI 53223 MX3672-01...
Need help?
Do you have a question about the WedgeSmart DCS and is the answer not in the manual?
Questions and answers