Network Sensor Features - Cisco Aironet 1800s Getting Started Manual

Network Sensor Features

A full listing of the network sensor's features and specification are provided in the Cisco Aironet 1800s
Network Sensor Data Sheet, at the following URL:
(URL to be added at CCO)
The features of the 1800s network sensors are as follows:
• The only supported mode of operation is as a network sensor for Wireless Service Assurance.
• Two integrated omnidriectional 2.4 GHz single band and 5 GHz single band antennas. Peak
antenna gain is approximately 3 dBi and 5 dBi in 2.4 GHz and 5 GHz bands respectively.
• Radio features supported are:
2.4 GHz and 5 GHz concurrent radios
–
2 GHz radio with 2TX x 2RX and two spatial streams SU-MIMO
–
5 GHz radio with 2TX x 2RX 802.11ac Wave 2 capable with two spatial streams SU-MIMO
–
and MU-MIMO
802.11ac based Transmit Beamforming
–
Quality of Service (QoS)
–
Radio Resource Management (RRM)
–
Rogue Detection
–
BandSelect
–
Bluetooth Low Energy 4.0
–
• Hardware external interfaces:
One 10/100/1000 BASE-T (Ethernet) Uplink Interface with inline power capability,
–
Auto-MDIX (automatically support either straight through or crossover cables), and
802.3af/at PoE.
RS-232 console interface, using a custom console cable AIR-MOD-UART-xx.
–
• Depending on the model of the network sensor and the mounting option chosen, it can be powered
using:
USB power 5V, 1.5A.
–
AC power, from Cisco-supplied AC Adapter, providing 120~240VAC, 50~60Hz power.
–
PoE power from a network device supplying 802.3af Class 0 power or greater. You can use
–
Cisco power injectors AIR-PWRINJ5 (for 802.3af) or AIR-PWRINJ6 (for 802.3at).
For more information on power and mounting options, see XXX.
• Reset button. For information on how to use the Reset button, see
section on page
4
25.
"Using the Reset Button"