Table of Contents
Advertisement
Available languages
Available languages
3
ADJUST THE SUCTION UNIT OF UP_SIDE
By default the click system is properly adjusted such, that the suction unit (990984) locks into place in the suction opening.
Adjust the click system (only in the following cases):
Suction unit (C) does not stay down = distance between A and B too large
Suction unit (C) cannot be fully pushed down = distance between A and B too small
If adjustment is still required, follow this instruction.
Adjust the click system (A) and the hook (B):
•
Remove the suction unit (C) from the hood and remove the lid (D) from the box.
•
Slightly unscrew the 4 capped nuts, so you can slide the foot (E) together with the click system (A) into the longitudinal
direction.
•
Place the suction unit (C) back and push it fully downwards.
•
Press the foot (E) together with the click system (A) until it is against the hook (B).
•
Tighten the capped nuts (manually).
•
Place back the lid (D).
4
ELECTRICAL CONNECTION
Set the selector switch to 'position II' (this is the default setting). This switch has been placed on the casing of the junction box.
Plug the power cable into an earthed wall socket.
•
The plug must always be accessible, so UP_SIDE can be disconnected from the mains whenever necessary.
•
Setting the selector switch to '0' also disconnects UP_SIDE from the mains.
•
In special cases (limited space, insufficient draught) the technician may opt to set the switch to position 'I'. In this energy-
saving position, the appliance will move significantly less air and therefore make significantly less noise.
EN 24
Advertisement
Table of Contents
