Electrical Connection - Novy 7811/2 Operating And Installation Instructions

Reset the Monoblock recirculation filter:
The cooker hood (motor) must be running!
Simultaneously press + and – for 5 sec. until the
red indicator lamp flashes 3 times for confirmati-
on. If the programming is not carried out, the pro-
gramming is automatically set after the chimney
hood has been switched on 10 times.
Place the Monoblock recirculation filter:
• Open the bottom plate with both hands and
remove the aluminium grease filter from the
hood.
• Place the Monoblock recirculation filter is its
opening in the cooker hood.
• Put back the aluminium grease filter and close
the bottom plate.
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood. Use a soft, wet cloth
and a mild detergent to clean the hood. Never
use aggressive, abrasive detergents or sponges.
Bleach will damage stainless steel. The stainless
steel surfaces can be treated with Novy Inoxclea-
ner (906.060) after cleaning.
Replacement of the led ligths
In the event of a malfunction, you can contact
your (kitchen) supplier and/or the Novy Customer
Service Department. In order for the Customer
Service Department to reply quickly and precise-
ly you must to tell them which type of extraction
hood you have. The model number can be found
on a sticker on the interior of the extraction hood.
This is visible as soon as you take the filter out
of the extraction hood. You can write down the
model number here:
Model number: ............................

Electrical connection

electrical output: electrical cord + plug with
ground. To be plugged into socket with ground.
Check for compatibility with information on type
plate (behind filter). Socket must be within reach.
Changes or replacement of the electrical cord
should be performed by a professional only.
Dimensions: p. 18
Electrical scheme: p. 19
EN 17