Table of Contents
Advertisement
Available languages
Available languages
2.2
FLUSH MOUNTING
Before installing the domino and/or the induction hotplate, please make the preparations below with respect to the appliances.
•
In order to be able to completely seal UP_SIDE after installation, apply a drip tray (990-987) to the bottom side of the
adjacent domino or induction hotplate only along the side lying against UP_SIDE.
•
Turn the appliance concerned and mark the centre of the side lying against UP_SIDE.
•
Also mark the centre of the drip tray and remove the protective layer from the adhesive strip.
•
Stick the drip tray unto the bottom side of the work surface of the domino or induction hotplate and make sure the tray is
centred and protrudes max. 2,5 mm along the edge of the appliance.
Place UP_SIDE at the correct position and first shut off the exhaust duct before laying the domino or the induction hotplate
into the cut-away.
EN 22
Advertisement
Table of Contents
