Usable Control Commands; D Command Description - Icom IC-R8600 Reference Manual

I/Q SIGNAL

■ Usable control commands

D Command description

Some commands can both read and write data, while others can only read or write.
Usable commands differ, according to the I/Q mode state (ON or OFF).
Sub
Command
command
Number
Number
05
11*
12*
14* 02
16* 02
65
1A 0E
0F
12
13* 00
01
02
Commands other than listed above
*(Asterisk) Send/read data
Data
See p.10 Set the receive frequency.
00, 10, Send/read the Attenuator
20, 30 ( 00=ATT OFF, 10=10 dB, 20=20 dB, 30=30 dB)
00~02 Send/read the antenna connector (only in the HF band)
(00=ANT1, 01=ANT2, 02=ANT 3)
0000~ Send/read the RF Gain
0255 (0000=Minimum, 0255=Maximum) (BCD value)
00/01 Send/read the PRE-AMP setting
(00=OFF, 01=ON)
00/01 Send/read the IP+ function status
(00=OFF, 01=ON)
Read the band edge Count
( Number of data in an edge unit returned in a BCD value.)
See p.10 Read the band edge frequency
00/01 The OVF Indicator status
(00=OFF, 01=ON)
00/01 Send/read the I/Q mode status
(00=OFF, 01=ON)
See p.11 Send/read I/Q Output setting
00/01 Send/read HF band BPF setting
(00=OFF, 01=ON)
Command Function
9
When the When the
I/Q mode is I/Q mode is
OFF ON
Not usable Usable
Not usable Usable
Not usable Usable
Not usable Usable
Not usable Usable
Not usable Usable
Not usable Usable
Not usable Usable
Not usable Usable
Usable Usable
Set to "ON":
Not usable
Set to "OFF":
Usable
Usable
Read setting:
Usable
Not usable Usable
Not usable Not usable