Rear Wheel - Yamaha AG100FA Owner's Manual

Rear wheel

To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the brake torque rod cotter
pin, the nut, and the bolt.
2
3
4
1. Brake torque rod
2. Brake torque rod cotter pin
3. Brake torque rod bolt
4. Brake torque rod nut
2. Remove the brake pedal free play
PERIODIC MAINTENANCE AND ADJUSTMENT
adjusting nut, and then disconnect
EAU25080
the brake rod from the brake cam-
shaft lever.
EAU49022
EWA10821
4
3
2
1
1. Wheel axle
2. Drive chain slack adjusting plate
3. Brake camshaft lever
4. Brake pedal free play adjusting nut
5. Brake rod
3. Loosen the axle nut and the rear
sprocket nut.
1
5
1. Axle nut
2. Rear sprocket nut
3. Drive chain slack adjusting plate
To install the rear wheel
7-31
(a)
2
3
1
4. Lift the rear wheel off the ground
according to the procedure on
page 7-28.
5. Turn the drive chain slack adjust-
ing plate on each side of the swin-
garm fully in direction (a).
6. Remove the axle nut.
7. Pull the wheel axle out together
with the drive chain slack adjusting
plate from the right-hand side.
8. Slide the wheel to the right, and
then remove it by pulling it back.
1. Install the drive chain slack adjust-
2
3
4
5
6
7
8
9
EAU49031