Replacing The Tail/Brake Light Bulb; Replacing A Turn Signal Light Bulb; Supporting The Motorcycle - Yamaha AG100FA Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
Replacing the tail/brake light
bulb
1
1. Remove the tail/brake light lens by
removing the screws.
2
3
4
3
5
6
1. Screw
2. Tail/brake light lens
3. Tail/brake light bulb
7
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
8
clockwise.
3. Insert a new bulb into the socket,
9
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws. NOTICE: Do not over-
tighten the screws, otherwise
the lens may break.
EAU24133
Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by pulling it outward.
1
1
2
1. Turn signal light lens
2. Turn signal light bulb
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens in the original posi-
tion.
[ECA10681]
EAU48930

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand up-
right. Check that the motorcycle is in a
stable and level position before starting
any maintenance. A strong wooden
box can be placed under the engine for
added stability.
2
To service the front wheel
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
7-28
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
EAU24350